Step One: Lay the paper out on the table with the
long side as shown. Fold in half to make a crease up the center..THEN,
fold the corners down to the crease... |
Step Two: Take the top point and fold it all the
way down to the bottom edge... Then un-fold so you've made a
crease |
Step Three: With the model flat again, fold the
tip down to the crease line you just made... |
Step Four: Next fold the top along the crease you've
already made.. All we're doing here is building up the leading
edge to get good flying balance and a tough little nose. This
is one of the safer fold n fly models and perfect for little
kids... Fly responsibly!! |
Step Five: Yet ANOTHER fold.,,,and again, to the
crease. |
Step Six: Grasp the outer edges and fold the airplane
back over itself..When you make this kind of fold, it's called
a "mountain fold" |
Step Seven: Fold the 'wings' down keeping the 'fuselage' depth
about one inch... Staple the fuselage together if you wish. |
Try adding a small paper clip to the nose of your flying wing.
Do some experimenting with slight bending of the flying surfaces
to get you wing to do it's thing. How about some insignias on
those wings? |
